Multimeter

The new Fluke 87 V series offers improved measurement and troubleshooting capabilities, as well as higher resolution and accuracy for diagnosing and solving problems in motor drives and power distribution, as well as in automation and electromechanics.

Ease of use and shock resistance.

The new 80V series measuring instruments are independently tested to comply with the 2nd edition of ANSI/ISA S82.01 and EN61010-1 CAT IV 600V/CAT III 1000V.

They can withstand voltage spikes of more than 8,000 V and reduce the problems associated with voltage dips and spikes.

functions

Unique function for precise voltage and frequency measurements on variable-speed motor drives, where

Harmonics superimposed on the fundamental frequency. Thanks to an integrated thermometer, you can easily take temperature measurements without having to carry a separate thermometer.

Optional magnetic hanger for easy setup and reading, while keeping your hands free for other tasks. Display with large digits and bright two-stage backlight ensures readability.,

that the 80 V series measuring instruments are significantly easier to read than older models.

• True RMS measurement of voltage and current for precise measurements on non-sinusoidal signals
• Switchable filter for precise voltage and frequency measurements on motor drives
• Basic inaccuracy of 0.05 % at DC voltage
• 6000 digits, 3-3/4 places
• 4-1/2 digits for precise measurements (20,000 digits)
• Measurement of up to 1000 V AC and DC
• Measurement of up to 10 A, 20 A for up to 30 seconds
• Integrated thermometer, so you need to take one less device with you (including TC probe)
• Frequency up to 200 kHz and % duty cycle
• Resistance measurement, continuity test and diode test
• 10,000 µF capacitance range for components such as motor capacitors
• Min/Max/Average value recording with Min/Max alert for automatic detection of deviations
• Peak value capture for recording short-term transients up to 250 µs
• Relative value mode for subtracting measurement lead interference in low-impedance measurements
• Automatic and manual range selection for maximum flexibility
• Touch Hold for capturing stable measurements without the influence of interference signals.
• Large display digits and two-stage bright backlighting for improved readability
• Analog bar graph display for rapid signal changes or unstable signals
• Input Alert emits an acoustic signal if the device is incorrectly connected to the input jacks.
• Flexible automatic shut-off to extend battery life
• Separate battery compartment for quick battery replacement without damaging the calibration seal.
• Classic design with new removable holster including integrated holder for test leads and probes
• Lifetime warranty

Electrical safety

All inputs are protected according to the 2nd edition of ANSI/ISA S82.01 and EN61010-1 CAT IV 600V and CAT III 1000V. They can withstand and reduce voltage spikes of more than 8,000V.

the problems associated with voltage dips and spikes.